Shop
Showing 913–936 of 1946 resultsSorted by price: high to low
-
-
IC's
LM324 – Low Power Quad Op-Amp (pack of 20)
Ask for Latest offer / Availability : https://bit.ly/3sWJQKC
- In the linear mode the input common-mode voltage range includes ground and the output voltage can also swing to ground, even though operated from only a single power supply voltage.
- The unity gain cross frequency is temperature compensated.
- The input bias current is also temperature compensated Advantages.
- Eliminates need for dual supplies.
- Four internally compensated op amps in a single package.
- Allows directly sensing near GND and VOUT also goes to GND.
- Compatible with all forms of logic.
- Power drain suitable for battery operation.
SKU: n/a -
IC's
L293D – H-Bridge Motor Driver (pack of 5 )
Ask for Latest offer / Availability : https://bit.ly/3c5BzxN
- The Device is a monolithic integrated high voltage.
- high current four channel driver designed to accept standard DTL or TTL logic levels and drive inductive loads.
- switching power transistors.
- allowing operation at a lower voltage and internal clamp diodes are included.
SKU: n/a -
Autonics Sensor
Autonics PR18-5DP DC 10~30 5mm M18 Inductive Proximity Sensor PNP-NO(Unshielded)
Ask for latest offers/availability : https://bit.ly/3mVHgAm
- Operating Voltage (VDC): 10 ~ 30
- Detection Distance (mm):5
- Outer Thread Size: M18
- Object Type: Inductive
- Output Type: PNP Normally Open Three-line
- Installation Type: Non-Flush (Unshielded)
- Max Output Current: 200 mA
- Setting Distance (mm): 0 ~ 3.5
SKU: PGI-00642319 -
Quad Copter & Multi Rotors
SimonK 30A BLDC ESC Electronic Speed Controller Without Connectors
Ask for Latest offers/availability : https://bit.ly/3mtbj49
- Model: SIMONK 30A.
- Constant Current: 30A (Max 40A < 10 sec).
- BEC: 5V 2A.
- Suitable Batteries: 2-3S LiPo.
- Application: BLDC Motors, Multirotor, Rc Planes etc.
SKU: PGI-00153463 -
-
AI Thinker Esp Wifi Modules
Ai Thinker LoRa Series Ra-02 Spread Spectrum Wireless Module
Ask for latest offers/availability : https://bit.ly/3aLQFUW
- Manufacturer: Ai-Thinker
- LoRa Spread Spectrum modulation technology
- Constant RF power output at + 20dBm-100mW voltage change
- High sensitivity: down to -148dBm
- Half-duplex SPI communication
- Programmable bit rates up to 300kbps
- Supports FSK, GFSK, MSK, GMSK, LoRa and OOK modulation modes
SKU: PGI-00319670 -
Temperature and Humidity Sensor
AM2301 Capacitive Digital Temperature & Humidity Sensor
Ask for latest offers/availability : https://bit.ly/3508i24
- Model: AM2301.
- Supply voltage: 3.3 ~ 5.2 V DC.
- Signal output form: Digital signal output.
- Temperature measurement range: -40 ~ +80 ºC.
- Temperature measurement precision: ± 0.5ºC
- Humidity range: 10%~90%RH.
- Humidity measurement precision: ±3%RH.
SKU: PGI-00347581 -
Led
1M WS2812B 5V Addressable RGB Non-Waterproof LED Strip Light 60LED’s/Mtr.
- Installation surface must be smooth, clean and dry
- The part of LED components cannot be fixed on the surface of the sharp edges
- The strip should not be collided or crushed
- The strip can be cut following the cutting lines
- 24-bit color control (8-bit PWM per channel); 16.8 million colors per pixel
- The one-wire digital control interface
- Each RGB LED draws approximately 50 mA at 5 V with red, green, and blue at full brightness
SKU: PGI-0056337 -
Esp Wifi Module, IoT and Wireless
ESP-32S Wifi Bluetooth Combo Module
Ask for Latest offer / Availability : https://bit.ly/3uYM7FU
- CPU and Memory: Xtensa® 32-bit LX6 Dual-core processor, up to 600 DMIPS.
- 448 KByte ROM
- 520 KByte SRAM
- 16 KByte SRAM in RTC.
- QSPI can connect up to 4* Flash/SRAM, each flash should be less than 16 Mbytes.
- Supply Voltage: 3V~3.6V
SKU: PGI-0029782 -
Thermoelectric Peltier Cooler
Thermoelectric Peltier Refrigeration Cooling System DIY Kit
Ask for latest offers/availability : https://bit.ly/3aE9rxt
- Using GL style of the refrigerator, effectively release the thermal deformation ability of the refrigerator produce at work.
- Small volume, does not occupy space, installation is simple.
- It can be used as a Pet Air Conditioner (chicken, little dog, etc.) or a little fridge.
- Lightweight, small size and easier to install.
SKU: PGI-00502117 -
IC's
PIC12F675 Microcontroller (pack of 5)
Ask for Latest offer / Availability : https://bit.ly/2NmLZi9
- High-Performance RISC CPU
-
Only 35 single word instructions to learn
-
All instructions are single cycle (1µs) except for program branches
-
Operating speed: DC – 20MHz clock input
-
Interrupt Capability
-
8-Level Deep Hardware Stack
SKU: n/a -
-
N20 Motor without Encoder
N20 3V 75RPM Micro Metal Gear Motor With Encoder
Ask for Latest offer / Availability : https://bit.ly/3hP1wEg
- Encoder Test Wire Length: 140mm.
- Wheel Dia.: 43 mm.
- Rated Voltage: DC 3V.
- Output Speed: 75RPM.
- Milling Edge: 0.5 mm.
- Output Shaft Size: 3 x 10mm.
- Output Shaft type: D type.
SKU: PGI-00467815 -
N20 Motor without Encoder
N20 6V 150RPM Micro Metal Gear Motor With Encoder
Ask for Latest offer / Availability : https://bit.ly/2UQa9p5
- Encoder Test Wire Length: 140mm.
- Wheel Dia.: 43 mm.
- Rated Voltage: DC 6V.
- Output Speed: 150RPM.
- Milling Edge: 0.5 mm.
- Output Shaft Size: 3 x 10mm.
- Output Shaft type: D type.
SKU: PGI-00476675 -
N20 Motor without Encoder
N20 12V 140RPM Micro Metal Gear Motor With Encoder
Ask for Latest offer / Availability : https://bit.ly/3esWmvP
- Encoder Test Wire Length: 140mm.
- Wheel Dia.: 43 mm.
- Rated Voltage: DC 12V.
- Output Speed: 120RPM.
- Milling Edge: 0.5 mm.
- Output Shaft Size: 3 x 10mm.
- Output Shaft type: D type.
SKU: PGI-00475625 -
N20 Motor without Encoder
N20 6V 50RPM Micro Metal Gear Motor With Encoder
Ask for Latest offer / Availability : https://bit.ly/3klcKlH
- Encoder Test Wire Length: 140mm.
- Rated Voltage: DC 6V.
- Output Speed: 50RPM.
- Milling Edge: 0.5 mm.
- Output Shaft Size: 3 x 10mm.
- Output Shaft type: D type.
SKU: PGI-00476547 -
N20 Motor without Encoder
N20 6V 200RPM Micro Metal Gear Motor With Encoder
Ask for Latest offer / Availability : https://bit.ly/2VF6jzu
- Encoder Test Wire Length: 140mm.
- Wheel Dia.: 43 mm.
- Rated Voltage: DC 6V.
- Output Speed: 200RPM.
- Milling Edge: 0.5 mm.
- Output Shaft Size: 3 x 10mm.
- Output Shaft type: D type.
SKU: PGI-00476696 -
N20 Motor without Encoder
N20 3V 35RPM Micro Metal Gear Motor With Encoder
Ask for Latest offer / Availability : https://bit.ly/2Ucwjlu
- Encoder Test Wire Length: 140mm.
- Wheel Dia.: 43 mm.
- Rated Voltage: DC 3V.
- Output Speed: 35RPM.
- Milling Edge: 0.5 mm.
- Output Shaft Size: 3 x 10mm.
- Output Shaft type: D type.
SKU: PGI-00476766 -
Autonics Sensor
Autonics PR12-4DP DC10~30 4mm M12 Inductive Proximity Sensor PNP-NO(Unshielded)
Ask for latest offers/availability : https://bit.ly/3eDUHC5
- Operating Voltage (VDC): 10 ~ 30
- Detection Distance (mm): 4
- Outer Thread Size: M12
- Object Type: Inductive
- Output Type: PNP Normally Open Three-line
- Installation Type: Non-Flush (Unshielded)
- Max Output Current: 200 mA
- Setting Distance (mm): 0 ~ 2.8
SKU: PGI-00642316 -
Encoder
N20 3V 150RPM Micro Metal Gear Motor With Encoder
Ask for Latest offer / Availability : https://bit.ly/3axhNcF
- Encoder Test Wire Length: 140mm.
- Wheel Dia.: 43 mm.
- Rated Voltage: DC 3V.
- Output Speed: 150RPM.
- Milling Edge: 0.5 mm.
- Output Shaft Size: 3 x 10mm.
- Output Shaft type: D type.
SKU: PGI-00476817 -
-
