Quad Copter & Multi Rotors
Showing 1–24 of 58 results
-
-
Prayog Blaster, Quad Copter & Multi Rotors
11.1V 2200 mah Lipo Battery for Quadcopter Helipcopter RC Planes
Prayog Blaster, Quad Copter & Multi Rotors11.1V 2200 mah Lipo Battery for Quadcopter Helipcopter RC Planes
- This Battery is made using high quality materials and gives long service life under standard conditions.
- The images are for reference only and not included with the battery.
- Do not get fooled by cheap batteries available at low cost.
SKU: n/a -
-
-
-
Quad Copter & Multi Rotors
30Amp Mini Opto BLHeli Multi-Rotor Electronic Speed Controller (BLHeli Firmware) SN30A
Quad Copter & Multi Rotors30Amp Mini Opto BLHeli Multi-Rotor Electronic Speed Controller (BLHeli Firmware) SN30A
- Designed specifically for multi-rotors
- Twisted servo cable to reduce interference
- Fast throttle response
- Low resistance MOSFETs
- Small and lightweight
- Thicker PCB for better heat dissipation
SKU: n/a -
Quad Copter & Multi Rotors
4 Axis F450 Quad copter Multi rotor Drone Frame
- Built from quality glass fiber and polyamide nylon.
- Integrated PCB connections for direct soldering of your ESCs
- Pre-threaded brass sleeves for all of the frame bolts.
- Colored arms for orientation to keep you flying in the right direction.
- Large mounting tabs on main frame bottom plate for easy camera mounting.
- Easy assembly.
SKU: n/a -
ESC /Speed Controller, Quad Copter & Multi Rotors
5V-12V DC Brushless Driver Board Controller For Hard Drive Motor 3/4 Wire
ESC /Speed Controller, Quad Copter & Multi Rotors5V-12V DC Brushless Driver Board Controller For Hard Drive Motor 3/4 Wire
- Drive voltage: DC 5-l2V
- Work current: ≤ 1.2A
- Dimensions mm (LxWxH): 64 x 46 x 16
- Weight: 23g
- Type: Voltage Regulator
- Speed range: from 0% to 100%
- Phase inversion Control: Yes
- Voltage polarity protection: Yes
SKU: n/a -
-
Prayog Blaster, Quad Copter & Multi Rotors
APM 2.8 Flight Controller with Built-in Compass
- Straight Needle
- Arduino Compatible!
- Onboard 4 MegaByte Dataflash chip for automatic data logging.
- Optional off-board GPS, a uBlox LEA-6H module with Compass.
- One of the first open source autopilot systems to use Invensense’s 6 DoF Accelerometer/Gyro MPU-6000.
SKU: n/a -
-
Quad Copter & Multi Rotors
DJI Naza-M LITE Multirotor Flight Controller Autopilot system
- Using 32-bit processor, compatible with DJI NAZA LITE V1 V2 flight controller, incomparably superior than 8-bit processor.
- Please take notice of the arrow on GPS, which stands for the head of flyer.
- Similar calibration and usage with DJI GPS.
- Coming with soft silicone gel cable 30cm; For softness, black rubber was wrapped on surface.
- Notice: black cable= GND, white cable=TX, yellow cable=RX, red cable=5V, 3.3-7.5V is ok)
Metal foil label has been mounted on the bottom of GPS to reduce signal interference from other electronic equipments.
SKU: n/a -
-
Drone/Quad-copter Remotes
FLY SKY FS IA6B RF 2.4GHz 6CH PPM output with iBus port receiver
- Input Power : 4.0 – 8.4 VDC (2A).
- Transmitting Power: ≤ 20 dBm.
- Model Type : Airplane / Glider / Helicopter
- Compatible Transmitter: Compatible with FS-i4, FS-i6, FS-i10, FS-GT2E, FS-GT2G
- 2.4G Mode: The second generation of an enhanced version of the automatic FM digital system.
SKU: n/a -
Drone/Quad-copter Remotes, Prayog Blaster
FlySky CT6B 2.4Ghz 6CH Transmitter with FS-R6B Receiver
- Super active and passive anti-jamming capabilities.
- Very low power consumption.
- High receiving sensitivity.
- 8 model memory, digital control.
- Can be programmed by PC with included software.
- Full range 2.4GHz 6-channel radio.
- 4-Model
- 4 Types (Airplane, Heli90, Heli120, Heli140).
- Integrated
SKU: n/a
