Arduino Sensors
Showing all 7 results
-
-
Arduino Sensors
Flame Sensor infrared Receiver Ignition source detection module
- Output Channel: 1
- Power Supply: 3.3/5V
- Built in a potentiometer for sensitivity control.
- Onboard signal output indication, output effective signal is high, at the same time the indicator light up, the output signal can directly connect to microcontroller IO.
- Detection angle about 60 degrees, the flame spectrum especially sensitive.
- The flame of the most sensitive sensors flame, the regular light is also a response, generally used for fire alarm purposes.
SKU: n/a -
Arduino Sensors
LDR Light Sensitive Resistor for Light Sensor (5 mm)
- The maximum voltage (V-dc): 150
- The maximum power dissipation (mW): 100
- Ambient temperature (° C): – 30 — +70
- Spectral peak (nm): 540
- Light resistance (10Lux) (KΩ): 2-5
- Dark resistance (MΩ):0.2
- Photoresistor is widely used in toys, lamps, cameras and other industries.
SKU: n/a -
-
Arduino Sensors
MQ-3 Alcohol Detector Gas Sensor Module
Ask for Latest offer / Availability : https://bit.ly/3q4yR0l
- Power requirements: 5 VDC @ ~165 mA (heater on) / ~60 mA (heater off).
- Current Consumption: 150mA.
- DO output: 0.1 and 5V.
- AO output: 0.1- 0.3 V (relative to pollution), the maximum concentration of a voltage of about 4V
- Detecting Concentration: 0.05-10mg/L Alcohol.
SKU: PGI-0029770 -
Arduino Sensors, Prayog Blaster
MQ-7 CO Carbon Monoxide Coal Gas Sensor Module
Ask for Latest offer / Availability : https://bit.ly/3llU5o7
- Operating voltage: DC 5 V.
- The analog output voltage, the higher the concentration the higher the voltage.
- The carbon monoxide detection with better sensitivity.
- With a long service life and reliable stability.
- Rapid response and recovery characteristics.
- Range: 10 to 1000 ppm.
SKU: PGI-0044007 -
Arduino Modules, Arduino Sensors
MT8870 DTMF Audio/Speech Decoding Telephone Module
- The MT8870 module is a low power device DTMF decoder chip. It is a complete DTMF receiver integrating both the band-split filter and digital decoding functions. This module is suitable for modem interfaces, mobile radios and other DTMF related applications.
SKU: PGI-00407537 -
Arduino Sensors, Prayog Blaster
Touch Sensor Switch Module
Ask for Latest offer / Availability : https://bit.ly/30PiLfi
- Main chip: LM393
- Working voltage: for DC 5V
- Single-channel signal output
- Low-level output signal used for human body touch sensor alarm
- Adjustable sensitivity
- Pin Connector to board: 4 Pins
SKU: PGI-00699624
